Parameters:1.
When connecting the left positive and right negative lights of the 2pin, the 2 and 3 needles can be inserted directly into the center, and the 1 and the 4 needles are empty.
Modul driver LED TV Backlight 35-65inch.
There are 4 output interface, the common definition for ++--.
No load will not burn the board (in the case of no load or lamp bar, the output voltage will fall to the input voltage size, or the load voltage is higher than 88V that will also reduce to the input voltage value).6.
If it\'s too dark, blinking, or flashing, please try to increase the current.5.
It won’t burn the lamp strip.
The default is only connected 1 R13 resistors, the output current is 80mA.
One resistor represents 80mA, and the highest 6 resistance fully connected to 480mA.4.
There are 6 of 1206 resistors on the motherboard.
It is convenient to change the current.
Output voltage: below 88V automatic.3.
With protection.2.
Definitions are all the same. Function:1.
Output interface definition: It is a four (++--) parallel interface.
Input interface definition: 1: power supply 2: power supply 3:ENA switch control 4: brightness adjustment signal (voltage dimming) 5: ground wire 6: ground wire6.
Suitable for light bar: large size 32inch -65 inch (maximum voltage 88V)5.
Highest 480mA.4.
Each resistor 80mA.
Increases the current by shorting the R22 R21 R18 R15 R24 resistor.
Output current: the default 80mA.
Output voltage: automatic adaptation below 88V (minimum limit for input voltage, no depressurization)3.
Power supply condition input: support 10-28V DC input2.
Parameters:1
