OPERATING MODES 802.11a/b/g/n Aruba Instant AP 802.11a/b/g/n Mobility Controller-managed AP Air monitor (AM) for wireless IDS, rogue detection and containment Spectrum analyzer Secure enterprise mesh Remote AP (RAP) when used with a Mobility Controller WIRELESS RADIO SPECIFICATIONS AP type: Indoor, Dual radio, 5-GHz and 2.4-GHz 802.11n 2x2:2 Software-configurable Dual radio supports 5-GHz (Radio 0) and 2.4-GHz (Radio 1) 2x2 MIMO with two spatial streams and up to 300 Mbps wireless data rate Supported frequency bands (country-specific restrictions apply): 2.4000 to 2.4835 GHz 5.150 to 5.250 GHz 5.250 to 5.350 GHz 5.470 to 5.725 GHz 5.725 to 5.850 GHz Support for up to 255 associated client devices per radio, and up to 16 BSSIDs per radio Available channels: Dependent on configured regulatory domain Dynamic frequency selection (DFS) optimizes the use of available RF spectrum Supported radio technologies: 802.11b: Direct-sequence spread-spectrum (DSSS) 802.11a/g/n: Orthogonal frequency-division multiplexing (OFDM) Supported modulation types: 802.11b: BPSK, QPSK, CCK 802.11a/g/n: BPSK, QPSK, 16-QAM, 64-QAM Transmit power: Configurable in increments of 0.5 dBm Maximum (aggregate, conducted total) transmit power (limited by local regulatory requirements): 2.4-GHz band: +21 dBm (18 dBm per chain) 5-GHz band: +21 dBm (18 dBm per chain) Advanced Cellular Coexistence (ACC) minimizes interference from LTE cellular networks Maximum ratio combining (MRC) for improved receiver performance Cyclic delay/shift diversity (CDD/CSD) for improved downlink RF performance Short guard interval for 20-MHz and 40-MHz channels Space-time block coding (STBC) for increased range and improved reception Low-density parity check (LDPC) for high-efficiency error correction and increased throughput Supported data rates (Mbps): 802.11b: 1, 2, 5.5, 11 802.11a/g: 6, 9, 12, 18, 24, 36, 48, 54 802.11n: 6.5 to 300 (MCS0 to MCS15) 802.11n high-throughput (HT) support: HT 20/40 802.11n packet aggregation: A-MPDU, A-MSDU POWER Maximum power consumption: 9.5W (POE) or 8W (DC) Power sources sold separately Direct DC source: 12 Vdc nominal, +/- 5% Power over Ethernet (PoE): 48 Vdc (nominal) 802.3af or 802.3at-compliant source ANTENNAS Two integrated dual-Band downtilt omni-directional antennas for 2x2 MIMO with maximum antenna gain of 4.0 dBi in 2.4 GHz and 4.5 dBi in 5 GHz. OTHER INTERFACES 10/100/1000BASE-T Ethernet network interface (RJ-45) Auto-sensing link speed and MDI/MDX 802.3az Energy Efficient Ethernet (EEE) PoE-PD: 48 Vdc 802.3af PoE or 802.3at PoE+ DC power interface, accepts 1.7/4.0-mm center-positive circular plug with 9.5-mm length Serial console interface (proprietary; optional adapter cable available) Visual indicators (LEDs): Power/system status Ethernet link status (ENET) Radio status (2x
RAD0, RAD1) Kensington security slot Reset button .
The downtilt angle for maximum gain is approximately 30 degrees.
Built-in antennas are optimized for horizontal ceiling mounted orientation of the AP.
OPERATING MODES 802.11a/b/g/n Aruba Instant AP 802.11a/b/g/n Mobility Controller-managed AP Air monitor (AM) for wireless IDS, rogue detection and containment Spectrum analyzer Secure enterprise mesh Remote AP (RAP) when used with a Mobility Controller WIRELESS RADIO SPECIFICATIONS AP type: Indoor, Dual radio, 5-GHz and 2.4-GHz 802.11n 2x2:2 Software-configurable Dual radio supports 5-GHz (Radio 0) and 2.4-GHz (Radio 1) 2x2 MIMO with two spatial streams and up to 300 Mbps wireless data rate Supported frequency bands (country-specific restrictions apply): 2.4000 to 2.4835 GHz 5.150 to 5.250 GHz 5.250 to 5.350 GHz 5.470 to 5.725 GHz 5.725 to 5.850 GHz Support for up to 255 associated client devices per radio, and up to 16 BSSIDs per radio Available channels: Dependent on configured regulatory domain Dynamic frequency selection (DFS) optimizes the use of available RF spectrum Supported radio technologies: 802.11b: Direct-sequence spread-spectrum (DSSS) 802.11a/g/n: Orthogonal frequency-division multiplexing (OFDM) Supported modulation types: 802.11b: BPSK, QPSK, CCK 802.11a/g/n: BPSK, QPSK, 16-QAM, 64-QAM Transmit power: Configurable in increments of 0.5 dBm Maximum (aggregate, conducted total) transmit power (limited by local regulatory requirements): 2.4-GHz band: +21 dBm (18 dBm per chain) 5-GHz band: +21 dBm (18 dBm per chain) Advanced Cellular Coexistence (ACC) minimizes interference from LTE cellular networks Maximum ratio combining (MRC) for improved receiver performance Cyclic delay/shift diversity (CDD/CSD) for improved downlink RF performance Short guard interval for 20-MHz and 40-MHz channels Space-time block coding (STBC) for increased range and improved reception Low-density parity check (LDPC) for high-efficiency error correction and increased throughput Supported data rates (Mbps): 802.11b: 1, 2, 5.5, 11 802.11a/g: 6, 9, 12, 18, 24, 36, 48, 54 802.11n: 6.5 to 300 (MCS0 to MCS15) 802.11n high-throughput (HT) support: HT 20/40 802.11n packet aggregation: A-MPDU, A-MSDU POWER Maximum power consumption: 9.5W (POE) or 8W (DC) Power sources sold separately Direct DC source: 12 Vdc nominal, +/- 5% Power over Ethernet (PoE): 48 Vdc (nominal) 802.3af or 802.3at-compliant source ANTENNAS Two integrated dual-Band downtilt omni-directional antennas for 2x2 MIMO with maximum antenna gain of 4.0 dBi in 2.4 GHz and 4.5 dBi in 5 GHz
